Need help?Do you have a question about the Martin RoboScan Pro 518 and is the answer not in the manual?
General| Resolution | Not applicable |
|---|---|
| Contrast Ratio | Not applicable |
| Throw Ratio | Not applicable |
| Prism | Rotating 3-facet prism |
| Focus | Motorized |
| Effects | prism |
| Control Protocol | DMX512 |
| Power Supply | 230V, 50 Hz |
| Housing | aluminum |
| Cooling | Fan cooled |
Essential safety guidelines for operating the RoboScan Pro 518, covering electrical, UV, burn, and fall hazards.
Key technical features and capabilities of the RoboScan Pro 518 moving-mirror intelligent projector.
Optional accessories available for the RoboScan Pro 518, including gobo sets.
Procedure for safely removing and installing the lamp in the RoboScan Pro 518 fixture.
Verifying and adjusting voltage and frequency settings to match the local AC power supply.
Instructions for installing a grounding-type plug on the power cord for safe operation.
Steps to remove shipping locks and prepare the pan/tilt assembly for use.
Guidelines for securely mounting the RoboScan Pro 518 fixture to structures, including safety considerations.
How to connect and configure the RoboScan Pro 518 for operation with DMX or Martin controllers.
Operating the RoboScan Pro 518 without a controller using preprogrammed sequences triggered by music or speed.
How to connect and operate the RoboScan Pro 518 using DMX-512 or Martin protocol controllers.
Information on controlling the lamp on/off via DMX, including cold re-strike requirements.
Details on the moving mirror's pan (176°) and tilt (85°) movement and resolution options.
Description of the 17 color positions, including dichroic, multi-color, UV-pass, and open white.
Information on the five interchangeable rotating gobos and their rotation capabilities.
How the dimmer/shutter system provides smooth dimming and strobe effects up to 9 Hz.
Details on the effects wheel, including frost filter, 3-facet prism, and CTC filter.
Reducing fan speed for quieter operation and the built-in thermostat safety feature.
How to manually adjust the fixture's focus using the lens barrel.
Using improved speed arrays with Martin controllers, requiring DMX mode 3.
Procedure for readjusting the lamp position for optimal light output and even distribution.
How to select DMX modes 1, 2, or 3 by changing a jumper inside the fixture.
Instructions for rewiring the ballast and transformer to match local voltage and frequency settings.
Procedures for readjusting pan and tilt mirror stops to correct positioning errors after a reset.
Explanation of the 3 DMX modes (tracking/vector, 8/16-bit resolution) and their channel requirements.
Detailed breakdown of DMX channels, their values, percentages, and corresponding effects for different modes.
Textual listing of the RoboScan Pro 518's physical measurements, including length, height, width, and weight.
Electrical specifications, including power consumption, voltage/frequency ranges, and fuse types.
Recommended lamps for the RoboScan Pro 518, including model, life, wattage, and color temperature.
Photometric data, specifically the focused beam angle of the fixture.
Details on the serial data link, including input/output types and pin assignments for DMX communication.
Diagram illustrating external dimensions and key physical features of the RoboScan Pro 518.
Table detailing DIP-switch settings for channels 1-511, showing pin configurations for different addresses.
To Next Page