MAS-110 Flex controls
As illustrated in the picture at the left there are
spaces for four switches.
Top: The tweeter control switch. This switch
will allow selection of one, no tweeters. The
default setting is (marked with an *) the single
tweeter setting.
Bottom: The Voicing control Switch. This
controls the signal phase between the Mid/High
section and the Woofer section. The default
setting (marked with an *) is in phase.
Arming Switch SW1: This switch arms or
disarms the Bright/Dark SW2 switch. The
default setting (marked with an *) is Neutral or
Off.
Bright/Dark SW2: This switch controls
Mid/High output in relation to the Woofer
section. The default setting (marked with an *)
is Dark. However, unless the Arming Switch
SW1 is lifted to the Arm SW2 setting SW2
remains inert and does not control the Mid/High
section.
Placing all the switches in their Default settings
places the cabinet in a Neutral voicing with an
even response curve. In this setting the
loudspeaker’s response is +/- 7db from 35Hz to
16Khz.
Switching in operation:
The MAS-110 Flex is shipped with all switches in the Default or Neutral setting.
This is a good place to start when finding desired tone. The instrument signal chain can
be adjusted and optimized prior to moving the Loudspeaker from its Neutral setting.
The Arming Switch SW1 on the 110 Flex allows the loudspeaker to leave the
Default Neutral voicing and move sensitivity control of the Mid/High section to the
To Next Page
General