5
ment within temperature range +5 to +40°C,
humidity 15 - 93 % RH and atmospheric pres-
sure 70 - 106 kPa (700 - 1060 hPa). If the
product has recently been stored or transported
at conditions
outside this range, please wait for
30 minutes before operating the product.
• Expected service life of this product and acces-
sories delivered with this product is three (3)
years, if operated as indicated above. Howev-
er, the guarantee times indicated in document
”TERMS OF SALES AND DELIVERY FOR MAS-
COT AS” apply (available at www.mascot.com).
• Environmental parameters during transport and
storage between uses: temperature range -25
to +85 °C, humidity 15 - 93% RH NC and at-
mospheric pressure 70 - 106 kPa (700 - 1060
hPa).
• If stored for longer periods of time the
environmental parameters should be within
the temperature range +5 to +35°C, humidity
range 10 - 75% RH NC and atmospheric pres-
sure 70 - 106 kPa (700 - 1060 hPa) to maintain
the products expected service life.
• Expected shelf life of this product is one (1) year,
if stored as indicated above.
• This product complies with the requirements to
electromagnetic compatibility for medical elec-
tric equipment and for use in residential, office
or light industrial environment but all electric
products imply a potential for electromagnetic
or other interference between the product and
other devices. If such interference is suspected
please disconnect the product from the mains
and consult a qualified technician, your supplier
or the manufacturer.
• No special maintenance procedure is required
but if the product gets dusty or dirty it should be
wiped clean using a dry cloth while the product
is disconnected from the mains. No other main-
tenance should be necessary.
• For products having a plastic casing, please
avoid any contact with lotions, oils, grease and
solvents as most types of plastic may be de-
graded by such chemicals. Also make sure to
position, operate and store such products away
from UV-light and direct sunlight.
• Position, operate and store this product only
under reasonable foreseeable environmental
conditions with respect to magnetic fields,
EM-fields, electrostatic discharges, pressure or
variations in pressure, acceleration etc.
• If this product is used with or mounted in a ve-
hicle it may only be used when the vehicle is not
in use.
• When in use, position this product so that the
label can be read – within 40 cm of the operator.
• Turn the product off and allow it’s housing to
cool down prior to moving it to another location.
• Lead-Acid chargers are designed for charging
Lead-Acid batteries only.
• Make sure you have the correct battery charger
for the Lead-Acid battery you wish to charge.
For safety reasons, individual battery types
should have a minimum capacity - please refer
to the specifications at the end of this manual.
• Do not attempt to charge batteries that are not
rechargeable.
• Please check that the specifications for your
battery allows for the maximum charge current
indicated on the charger.
• Please check that the specifications for your
Cautions to observe prior to charging Lead-Acid batteries
To Next Page
Loading...
