Adjustable Pedals
(optional)
The adjustable pedals system is
designed to allow greater range of
pedals positions enabling driver
comfort with regard to the steering
wheel tilt and the seat position.
This feature allows the brake and
accelerator pedals to move toward or
away from the driver’s feet.
The switch is located on the front side
of the driver's seat cushion side shield.
Press the switch downward to move
the pedals forward (toward the front
of the vehicle).
Lift the switch upward to move the
pedals rearward (toward the driver).
WARNING!
Do not adjust the pedals position
while the vehicle is moving. You could
lose control and have an accident.
Always adjust the pedals position
while the vehicle is parked.
The following messages will be
displayed if the driver is attempting to
adjust the pedals when the system is
locked out:
• “Adjustable Pedals Unavailable
While in Reverse”;
• or “Adjustable Pedals Unavailable
While Cruise Engaged”.
NOTE:
For vehicles equipped with driver
memory seat, use your key fob (RKE)
transmitter or the memory buttons on
the driver's door trim panel to return
the adjustable pedals to programmed
positions. See “Driver Memory Seat”
in section 3 for further information.
CAUTION!
Do not place any object under the
adjustable pedals or obstruct its
movement as it may cause damage to
the pedal controls. Pedal movement
may become limited if there is an
obstruction in the adjustable pedal's
path.
Rear-View Mirrors
External Mirrors
External mirrors can be adjusted
electrically and are equipped with anti
fog resistors operated by the air
conditioning system (see “Air
Conditioning Controls” in section 4).
The mirrors can be folded electrically
and will yield in both directions in case
of a collision.
The external mirrors can be
electrochromic (for versions/markets,
where provided), which means, they
automatically operate an anti glare
function by gradually shading as the
light hitting the mirrors increases.
The exterior of the rear-view mirror
support is equipped with LEDs,
lighting up when the turn signals and
vehicle entry/exit lights are activated.
NOTE:
• The mirrors can be adjusted
electrically only with the ignition
device in RUN position.
• When the vehicle is started, the BSA
warning light will momentarily
illuminate in both outside rear view
mirrors to let the driver know that
the system (optional) is operational.
For more details see chapter “Blind
Understanding the Vehicle
3
101
To Next Page
Loading...
