• on the fuse and relay box located in
a covered area, behind the glove
compartment on the dashboard left
side.
Integrated Power Module
• To access the module it is necessary
to lift the hood (see “Hood
Operation” in section “Before
Starting”).
• To access the fuses remove the
module cover unhooking the lateral
locks as shown in the picture.
The table points out the position as
featured in the figure, the type and
function of the fuses included in the
integrated power module.
CAUTION!
• After replacement, refit the
protective cover of the module.
• If you need to wash the engine
compartment, do not direct the
water for too long directly on the
module.
Ref. Type Function
2––
3––
4 Maxi – 30A
Starter motor
relay input
5 Maxi – 40A
ABS-ESP pump
feed
6 Maxi – 30A
AWD module
(AWD version
only)
7––
8 Maxi – 40A
ABS-ESP valve
feed
9––
10 – –
11 Mini – 20A Horn relay input
12 Mini – 10A
AC compressor
feed relay input
13 – –
14 Mini – 7,5A Alarm siren
15 Mini – 10A
Washer heated
nozzles relay
input
Maintenance and Care
7
338
To Next Page
Loading...
