Maserati Ghibli 2019 - Rear Power Distribution Center

Ref. Type Function
36 Mini – 30A
PCM module
primary load
37 Mini – 15A
Engine secondary
load
38 Mini – 15A Lambda sensor
39 Mini – 7,5A
Flow meters,
tank lackage,
canister, exhaust
by-pass valve and
relay coil
48 – –
49 Mini – 10A
Pedal brake
switch - TCM
module
50 Mini – 15A +30 PCM module
51 Mini – 30A
Fuel pump relay
input
52 Mini – 5A
Starter solenoid
signal for PCM
and voltage
stabilizer
53 Mini – 10A
AWD module
(AWD version
only)
Rear Power Distribution Center
• To access the center it is necessary to
lift the ground coverage of the trunk
compartment and remove the access
cover (refer “Maintenance Free
Battery” in this section).
• To access the fuses, unhooking the
cover lock shown in picture.
• Press the release latch and lift the lid
from this side.
• Push the lid toward the right side to
release the indicated latches on the
unit.
The table points out the position as
featured in the figure, the type and
function of the fuses on the rear area
distribution control unit.
Ref. Type Function
2 Maxi – 40A BCM module
3 Maxi – 40A BCM module
4 Maxi – 30A BCM module
5 Maxi – 30A BCM module
6 Maxi – 20A Sunroof module
7 Maxi – 30A
Driver door
module
8 Maxi – 30A
Passenger door
module
9 Maxi – 40A
Start&Stop:
voltage stabilizer,
dashboard
Maintenance and Care
7
340