4
139
Dashboard Instruments and Controls
High Beams and Flashing
To switch on the high beams with
the light switch in headlamp
or "AUTO" position, shift the
multifunction lever onward.
A related telltale will illuminate
on the tachometer.
By pulling the lever backward (toward
the steering wheel) you switch off the
high beams and switch on the low
beams.
You can signal another vehicle with
your headlights by lightly pulling the
multifunction lever toward you. This
will turn on the high beams headlights
until the lever is released.
Flashing occurs also with lights off if
the ignition device is RUN position.
CAUTION!
The high beams can only be switched
on manually by pushing the
multifunction lever forward.
WARNING!
If the high beams are activated, they
will turn on automatically every
time the low beams are switched on
either manually or automatically. We
recommend therefore that you switch
them off when they are no longer
necessary and every time the twilight
sensor deactivates the external lights.
To Next Page
Loading...
