4
145
Dashboard Instruments and Controls
• If you do not enter all PIN digits, a
prompt will indicate that you should
do so.
• In case of incoming call while
entering the PIN, the MIA system will
temporarily stop the release function.
As soon as the call is over, the keypad
screen will be displayed again so that
you can enter the PIN.
• When the next page shown in figure
appears, touch "OK".
Glove box is now locked and the MIA
will go back to "Controls" page. In this
condition, system operation is reduced
and only "Climate", "Controls" and
"Settings" functions are active.
Glove Box Deactivation Procedure
To unlock the glove box which has
been locked with PIN code, touch
"Vehicle" category soft-key and open
the "Controls" menu.
• Touch the “Glove Box” soft-key to
enter this page.
• Unlock glove box by entered the lock
code as previously specified.
• Touch "OK" to deactivate the
function.
Glove Box Manual Unlock
If battery is flat, it is necessary to
manually unlock the actuator on the
LH side of the glove box in order to
open the glove box that has been
locked using the PIN code.
To perform this operation you need to
remove the lower dashboard moulding
to access the actuator unlocking cable.
Considering the complexity of this
operation, we recommend you to
contact the Service Network.
Valet Mode Activation Procedure
• Open "Profiles" screen and touch
"Valet mode" soft-key.
• Touch "Yes" soft-key in the function
described screen to activate the
function.
• Using the keypad, enter the four
digits of the PIN and touch "GO".
To Next Page
Loading...
