6
213
Driver Assistance Systems
Speed Limiter - SL
Using the controls located on the left
side of the steering wheel, the driver
can set a maximum speed limit (SL
function) or maintain a constant cruise
control (CC function) speed without
operating the accelerator pedal. If
set, these two functions SL and CC will
exclude each other according to the
driver’s maneuvers.
SL allows the driver to set the
maximum speed limit to be reached by
the vehicle.
It is possible to exceed the set
maximum speed by firmly pressing
on the accelerator pedal. After that,
if the SL function is still active, once
the driving speed returns under the set
value, the SL function will continue to
limit the speed.
Controls
The controls are located on the left
side of the steering wheel.
Control configuration depends on
which driver assist systems are installed
to the vehicle.
In the standard and optional
configuration there is a specific button
to engage and disengage the SL.
Standard Configuration
Optional Configuration
Control buttons have the following
functions:
ON/OFF button to en-
gage/disengage SL system.
Multifunction switch:
• Press up (indication RES
+): increase speed, set
current speed or resume
previously set speed when
system is in "cancelled"
status;
• Pushed (indication CANC):
pause (SL disengaged).
The set limit is not deleted
(see paragraph “Tempor-
ary Deactivation" in this
chapter).
• Press down (indication
SET -): set speed/decrease
speed.
NOTE:
The figures only show the Standard
Configuration.
Displayed Information
Apart from the pop-up messages at
the center of the display, SL system
status is represented by icons at the
top left of the TFT display, in the
dedicated area. See "TFT Display
Areas" in section "Dashboard
Instruments and Controls".
Displayed information depends on
system status: ready, set, temporarily
cancelled or override.
To Next Page
Loading...
