6
214
Driver Assistance Systems
Activation
Push the ON/OFF button to engage
the system. The white light in
upper left sector of the TFT display will
illuminate.
To disengage the system, push the
same button a second time. The
light will turn off and a new message
pops up for 5 seconds, then the display
returns to the previous setting.
When the SL function is activated, the
system automatically disengage the CC
function if it was active. See chapter
"Cruise Control - CC" in this section for
further information.
NOTE:
The system must be disengaged when
not in use.
Speed Range of Use
Speed km/h (mph)
Minimum 0
Engaged/activated 30 (18)
Maximum 250 (155)
Setting
Turn on the SL function when the
vehicle has reached the desidered
speed, push downward the
multifunction switch (SET-) and release
it: the system sets and visualizes under
the green light the current speed
limit (in the example shown 30 km/h).
Pushing the multifunction switch
upward (RES +) or downward (SET
-) once, or by holding it down, will
enable to increase or decrease the set
speed by one unit (1 km/h or 1 mph).
If the car is equipped with ADAS
Systems, the single press of the
multifunction switch will increase or
decrease the set speed of 1 km/h or
1 mph; a continuous pressure of the
same will increase or decrease the set
speed of 10 km/h or 5 mph.
Release the switch when the desired
speed is reached, and the new set
speed will be visualized below the
green light.
The set speed memory can only be
erased by pressing the ON/OFF
button or by turning the ignition off.
Temporary Deactivation
A single or continuous press of the
multifunction switch (CANC), with SL
function on, erases temporarily the
set speed memory, that will remain
displayed under the white light.
Pressing the brake pedal the SL
function remains engaged, while the
To Next Page
Loading...
