6
215
Driver Assistance Systems
CC function, if it was active will be
temporarily deactivated.
Resume Speed
To resume a previously set speed, push
upward the multifunction switch
(RES+) and release it.
If you resume the set speed, but
driving at a higher speed, the message
shown in the picture below appears on
the TFT display and a buzzer alerts the
driver.
The system cuts the engine torque and
the green light with below the set
speed will turn on.
Drive Override
If the driver presses the accelerator
pedal to overtake another vehicle and
exceeds the set speed limit, an alert
message pops up for 5 seconds until
you return below the set limit. The
green light remain on.
It is possible to do so at any driving
speed, considering that it is possible to
set a minimum speed of 30 km/h (18
mph).
Cruise Control - CC ( )
Using the controls located on the
left side of the steering wheel, the
driver can maintain a constant cruise
control (CC function) speed, without
operating the accelerator pedal, or set
a maximum speed limit (SL function). If
set, these two functions CC and SL will
exclude each other according to the
driver’s maneuvers.
The CC enables the driver to maintain
the desired vehicle speed without
pressing the accelerator pedal,
reducing driving fatigue on highways,
especially long trips, as the set speed
is automatically maintained. A firm
press on the accelerator pedal or
the braking pedal will temporarily
deactivate the cruise control function.
CAUTION!
The device can only be switched on at
speeds exceeding 30 km/h (18 mph)
and it switches off automatically when
the brake pedal or the accelerator
pedal is pressed.
To Next Page
Loading...
