Maserati Ghibli - Active Driving Assist - ADA

6
249
Driver Assistance Systems
WARNING!
Many unforeseen conditions can
occur that can affect the performance
of Active Driving Assist (ADA).
Always keep this in mind and drive
attentively. Be prepared to take over
control of the vehicle immediately at
any time.
System in Faulty
The ADA system cannot properly
operate due to a fault of its
components, or because the
components themselves or their
detection area is obstructed.
In these cases the amber warning
light and the related message will be
displayed on the instrument cluster.
In this condition avoid using the
system and have the vehicle inspected
at the Service Network.
Radar Device - Regulatory
Information
The "Regulatory Information" for
all the radio frequency and radar
devices can be consulted by accessing
the section "Services" on the website
www.maserati.com.
Traffic Sign Assist - TSA
( )
TSA detects traffic signs through the
use of a forward-facing digital camera
mounted on windshield, behind the
rear-view mirror and assists the driver
by displaying detected speed limits
and overtaking restrictions in the
instrument cluster. The camera also
detects traffic signs with a restriction
indicated by an additional sign (e.g.
in snow conditions). TSA also uses the
data of the navigation system, in order
to provide information to the driver
in all cases in which the camera is not
able to detect the traffic signs that are
present on the road where the car is
travelling.
Some examples of these are: due to
low visibility, light reflection, damaged
traffic signs, traffic signs in wrong
position like rotated or fallen poles.
NOTE:
• Overtaking restriction sign will be
displayed only in markets where this
is allowed.
• TSA provides a visual warning to the
driver when he/she unintentionally
reaches the maximum speed limit
allowed or when it exceeds the set
"Sensitivity" value.
• The performance of TSA depends
on the update degree of navigation
system’s maps.
Customised Settings
TSA is configurable by the customer
regarding the display mode on the
instrument cluster and the warning
sensitivity.
Entering "Vehicle" page on MIA
display and select the "Traffic Sign
Assist" soft-key of the "Settings" menu
to enter the setting page.
The check mark on the "Warning
Mode" box indicates that the warning
function is active.
The display of the traffic signs can be
blinking or static.
The system can be set to display the
traffic signs when the speed of the
vehicle is equal to the speed limit
allowed, or when it is higher than 5 or
10 km/h (5 or 10 mph).