7
266
In an Emergency
Procedure Valid for 2.0 L4 MHEV
Model
• Release the straps that anchor the
compact spare wheel bag to the boot
compartment floor.
• Remove the bag from the boot
compartment.
2.0 L4 MHEV
• Lift the ground coverage of the boot
compartment.
• Sliding upwards the preformed
container containing the compressor
from the rear of the boot
compartment.
2.0 L4 MHEV
• Remove the compressor from the
preformed container.
2.0 L4 MHEV
• Remove the compact spare wheel
and other tools from inside the bag.
Compact Spare Wheel Installation
• Using the kit spanner, loosen
anticlockwise by approximately one
turn the five bolts on the wheel
to be changed. In case a “Wheel
Security Stud Bolt” is installed, it
can only be loosened and removed
by using the specific fitting spanner
insert provided with the “Wheel
Security Stud Bolt Kit”, available in
the “Genuine Accessories” range. In
this case, the insert must be installed
on the kit spanner.
• Place the jack near the wheel to be
changed as illustrated. Make sure
that the head of the jack is correctly
inserted in one of the slots 1 or 2
under the longitudinal member.
To Next Page
Loading...
