7
267
In an Emergency
WARNING!
•
Never position yourself under a
jacked vehicle.
•
Jack wrong positioning can
cause vehicle accidental fall, with
consequent severe risk for operator’s
safety and damages to vehicle body.
•
Never use the jack to carry out
maintenance or repairs under the
vehicle.
• Insert the kit spanner on the
hexagonal end of the jack and turn
it clockwise until the jack bracket is
firmly inserted in the slot under the
longitudinal member.
• Turn the jack lever until the wheel
is raised a few centimeters off the
ground.
• Completely unscrew the five bolts
and remove the wheel.
• Make sure that the contact surfaces
between spare wheel and hub are
clean and free of impurities.
• Fit the compact spare wheel with the
valve stem side out and secure it with
the five bolts previously removed,
without tightening them.
• Remove from the compressor case
the inflation hose and the cable with
a plug for the power outlet.
• Unscrew the valve cap of the compact
spare wheel and screw the fitting of
the inflation hose onto the valve.
• Insert the plug inside one of the
available power outlets fitted in the
boot or passenger compartment.
• Set the ignition device on ACC or
RUN position.
• Turn the compressor on by pressing
the switch.
• Stop the compressor pressing
switch again, when the pressure
indicated by the gauge reaches
the recommended level of 350 kPa
- 3,5 bar - 51 PSI ( : chapter
“Tire Inflation Pressure” in section
“Technical Specifications”) and screw
the cap on the compact spare wheel
valve.
To Next Page
Loading...
