2
27
Understanding the Vehicle
Rear seats heating can be adjusted
by operating control devices on
the panel located on the rear side
of the central console. The panel
also includes command for the rear
window sunshade (see “Rear Window”
in section “Before Starting”).
WARNING!
•
Persons with low skin sensitivity
because of advanced age, chronic
illness, diabetes, spinal cord injury,
medication, alcohol use, exhaustion
or other physical conditions must be
careful when using the seat heater.
It may cause burns even at low
temperatures, especially if used for
long periods of time.
•
Do not place anything on the seat
that insulates against heat, such as
a blanket or cushion. This may cause
the seat heater to overheat. Sitting
in a seat that has been overheated
could cause serious burns due to the
increased surface temperature of the
seat.
The buttons on the panel with the
resistance icon activate the heating on
one or both seats.
• Push the button once to select the
highest heating level. The two LED
beside of the icon will illuminate.
• Push the same button a second time
to select the lowest level. Only the
lower LED remains illuminate.
• Push the same button a third time to
shut the heating elements OFF. The
LED will turn off.
NOTE:
• Once a heat setting is selected,
heat will be felt within two to five
minutes.
• The engine must be running for the
heated seats to operate.
By selecting the HI-level setting, the
heater will provide a boosted heat
level during the first four minutes of
operation. Then, the heat output will
drop to the normal HI-level.
By setting the HI-level, the system
will automatically switch to LO-level
after a maximum of 60 minutes of
continuous operation. The LO-level
setting will turn off automatically
after a maximum of approximately 45
minutes.
To Next Page
Loading...
