4
95
Dashboard Instruments and Controls
set on the navigator of the MIA. If
function is set to "Off", the navigation
information will not be displayed.
"Key-On Display" and "Key-Off
Display" items allow user to set display
during vehicle key-on and off.
"Key-On Display" is normally set to
"On". When entering the vehicle,
after the welcome screen, the display
will show the information concerning
engine starting sequence. While if
it is set to "Off" (example shown in
figure), the display will show the
information displayed before last
vehicle key-off.
When engine is started and ignition
device is pressed to stop it, it is
possible to set "Key-Off Display", "On"
or "Off" to obtain the following
display settings:
• "On": Trip summary screen (Trip B is
reset after each key-on/key-off cycle);
• "Off": screen with Maserati logo and
trident.
The "Defaults" item of "Screen Setup"
submenu allows restoring Maserati
factory settings.
TFT Display: Menu and
Submenu Content
1. MAIN MENU
Press and release the multifunction
switch in the or arrow
directions until this menu item is
displayed. Pressing and releasing the
multifunction switch will toggle
the unit of measure between km/h or
mph.
Further to speed, the main area can
indicate three lines that can be set to
the same options and in the top right
or top left area. When these three
lines are present and turn-by-turn
navigation is on, main menu area
will automatically show navigation
information. For further details,
please refer to “Maserati Intelligent
Assistant™ (MIA)” guide.
To Next Page
Loading...
