EasyManua.ls Logo

Maserati GRANCABRIO - Front seats

Maserati GRANCABRIO
262 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C
4
101
Anti-intrusion and anti-lift alarm
device deactivation.
The anti-intrusion/anti-lift alarm
device may be deactivated by pressing
the button C, on the roof panel,
when the key is on MAR or within
one minute from turning the engine
off (key at STOP). Deactivation is
signalled by the LED on the button
ashing for 3 seconds.
WARNING: deactivation of the anti-
intrusion and anti-lift protection
devices remains memorised until
the next alarm system activation.
Therefore, if these protection devices
are deactivated but the alarm
system is not activated within a very
short time, their deactivation will
remain stored until the next system
activation, regardless of wether the
vehicle is turned on or off.
Alarm memory
If the warning light appears
on the display when the vehicle is
started, accompanied by the message
“Break-in attempt detected” this
means that an intrusion has been
attempted during your absence.
The alarm system memory is reset
when you turn the ignition key.
Ministerial homologation
The electronic alarm system device
is compliant with the legislation
applicable in all countries where
laws covering radio frequencies are
provided.
The homologation number can be
found at the end of this manual,
before the table of contents.
For those markets that require the
transmitter and/or receiver marking,
the homologation number is found
on the component.
Ordering extra radio operated
controls
To purchase new keys with radio
control, exclusively contact the
Maserati Service Network, bringing
with you:
- all the keys with radio control in
your possession;
- the Maserati CODE system CODE
CARD;
- the electronic alarm system CODE
CARD;
- your identity card;
- the identifi cation and registration
documents proving ownership of
the vehicle.
WARNING: The radio controls not
handed over for the new code
storage procedure will automatically
be deactivated in order to prevent
any lost or stolen radio controls
from being used to deactivate the
electronic alarm system.

Table of Contents

Related product manuals