B
C
D
4
114
Direction indicators
The lever has 3 positions:
B - direction indicators off;
C - lever up: right-hand direction
indicators;
D - lever down: left-hand direction
indicators.
Lane change function
This function allows you to activate
either the right-hand or left-hand
direction indicators so that they fl ash
3 times, without moving the lever to
positions C or D, and then move it
back to the standby position, B.
To activate this function, you must
simply start moving the lever to a
different position: if you move it up
you activate the right-hand direction
indicators, if you move it down you
activate the left-hand direction
indicators.
This function is useful when
overtaking or changing lanes.
High beams
To turn on the high beams with the
light switch in position
, push
the left-hand lever towards the
dashboard.
Pull the lever towards the steering
wheel again to turn off the high
beams and turn on the low beams.
WARNING: For the use of the high
beams, follow applicable Driving
Regulations.
Flashing the headlights
The headlights can be fl ashed by
pulling the left-hand lever towards
the steering wheel.
Flashing occurs also with the lights off
if the ignition key is in position MAR.
WARNING: Flashing occurs with
the activation of both FTP (Flash To
Pass) high beams. Always observe
applicable Driving Regulations to
avoid penalties.
To Next Page
Loading...
