S
P
T
P
6
184
- Remove the cover S from the power
socket located inside the luggage
compartment or open the shutter,
located on the centre console, to
uncover the socket T and insert the
plug P.
- Turn the ignition key to MAR to
supply power to the socket and
turn the compressor on by pressing
the switch R.
- Stop the compressor when the
pressure indicated by the gauge O
is 3,5 bar (350 kPa - 50.8 psi) and
screw the cap on the valve.
WARNING: In order to obtain a more
accurate reading, the compressor
should be switched off when checking
the tyre pressure with the pressure
gauge.
WARNING: Do not run the compressor
for more than 20 minutes as there is a
risk it could overheat. The compressor
has been designed exclusively to
infl ate compact spare wheels; do
not use it to infl ate air mattresses,
dinghies etc.
WARNING: Power is only supplied
to the socket when the key is on
MAR and can only be used with
accessories that have a maximum
absorption of 15A (180W power). Do
not connect accessories with a higher
absorption than that indicated to the
power socket. Any prolonged power
absorption may discharge the battery,
subsequently preventing the engine
from starting.
- Fit the adapter M on the spanner
L. Extend the spanner for use
as shown, and then loosen by
approximately one turn the fi ve
bolts on the wheel to be changed.
To Next Page
Loading...
