3
84
“Countries of Operation” table
No. of LED
fl ashes
Mode Countries covered
1 Rest of Europe A, B, CZ, CY, DK, FIN, D, GBZ, GR, H,
IRL, IS, L, M, NL, N, PL, DOM, P, SK, E,
S, CH, FL, ZA, UAE, RCH, EST, LT, SLO,
RUS, LV
2 France F, KWT, MC
3 United Kingdom GB, KWT, SA
4 Italy I, AUS, HKJ, AND
Programming
- Press and hold buttons O and Q.
- After about 20 seconds, the LED R
starts fl ashing.
- Release the buttons.
- Hold the remote control for the
device to be controlled close to the
HomeLink control panel (0-30 cm/
0-12 in).
- Simultaneously press and hold the
button on the hand-held remote
control and one of the three
HomeLink buttons O, P or Q.
- Successful programming is signalled
by the LED R fl ashing faster.
- Release the buttons.
To program the other buttons, repeat
the operations skipping the fi rst three
steps.
Use
- When the signal of the device to
be activated reaches its operating
range, press the dedicated
HomeLink button.
- The LED R remains on while the
signal is being transmitted.
The devices controlled through the
HomeLink function can always be
activated using the original remote
controls.
Should the so programmed HomeLink
not activate the system to be
controlled, this may be due to the
fact that this system is controlled by
a remote control with an alternate
code.
An alternate activation code can be
recognised in the following ways:
- consulting the instruction manual
provided with the device to be
controlled;
- despite the fact that the HomeLink
programming procedure has been
carried out correctly, the HomeLink
function does not activate the
device;
- holding the dedicated HomeLink
button pressed down, the LED
briefl y fl ashes fast and then
remains on for 2 seconds; this
sequence is repeated for about 20
seconds.
To Next Page
Loading...
