6
If a tire gets a puncture
139
– Open the compressor cover and take
out the hose with the pressure
gauge N and the electric wire O with
the power plug.
– Unscrew the spare wheel's valve cap
and screw down the union P for the
inflating pipe on the valve.
– Open the cap of the power plug R,
housed in the right hand side of the
luggage compartment, and insert
the connection O.
– Turn the ignition key to MAR to
supply power to the plug and
activate the compressor pressing
switch Q.
– Stop the compressor when the
pressure indicated on the pressure
gauge N is 2.5 bar (250 kPa / 35 psi)
and screw the valve cap.
WARNING: We recommend to check
the tire pressure on the gauge when
the compressor is off, in order to have
a more precise reading.
WARNING: Do not use the compressor
for more than 20 minutes: risk of
overheating! The compressor has been
designed for inflating the spare wheel
only; do not use it to inflate
mattresses, rubber boats etc.
WARNING: Power is supplied to the
current plug only when the key is
turned to MAR and it can only be
connected to devices with a power
absorption of 15A maximum (180W
power). Do not connect devices with a
higher power absorption to the
current plug. A prolonged power
absorption can discharge the battery,
preventing the engine from being
started once again.
– Fit the bushing K onto the wrench J
and loosen the 5 fastening studs on
the wheel to be replaced by about
one turn.
O
Q
N
P
R
To Next Page
Loading...
