Maserati GranTurismo 2024 - Functions of Settings Menu on MIA

4
162
Dashboard Instruments and Controls
transmission in R (Reverse) mode, the
initial view will be the default view
(associated with current gear state).
See “Surround View Camera System”
in section “Driving and Driver
Assistance Systems” for further details.
• Rear Parking Camera
This function allows you to switch on
the Rear Parking Camera.
See "Rear parking Camera" in section
"Driving and Driver Assistance
Systems" for further details.
• Glove Box
This function allows you to enter a 4-
digit PIN code to lock and unlock the
glove box in the passenger side of the
dashboard.
See "Access the Glove Box
Compartment" in section "Before
Driving" for further details.
Functions of Settings Menu
on MIA
The MIA system uses a combination of
keys able to access and change the
customer programmable functions
present in the "Controls" or "Settings"
menu of the "Vehicle" screen page.
A shortcut to set the customer
programmable functions is available in
the "Apps" screen page.
Once you enter the “Settings” screen,
use the touch soft-keys to scroll and
change settings of the customer
programmable functions.
NOTE:
• All settings must be edited with
ignition device set to ON position.
• Some of the customer programmable
functions are optional or for a specific
model/version and may not be
available on your vehicle.
• Only one touch screen area/soft-key
may be selected at a time.
Modes for Setting a Function
To enter the desired function, touch the
corresponding soft-key on the lateral list
(the picture shown is “Display”).
To scroll through the functions of the list,
move the cursor up or down, or touch
the arrow or until the function to
be set is displayed. Touching the or
soft keys and the cursor on the right
side of the screen will allow you to scroll
up or down through the available setting
options. In this screen one or more
boxes may indicate status or possible
variants of the function. A check mark in
a box indicates the active status of the
function.
When in a setting line with many options:
• touching on the option currently not
selected (no check mark in option)
move the selector and change the
option accordingly;
• touching on the option already selected
(with selection) do not perform action
(maintain the option selection).
When in a setting line with one option
only: