Maserati GranTurismo 2024 - Mobile Phone Pairing

4
172
Dashboard Instruments and Controls
(Continued)
Non-observance of the previous
indications could fail partially or at all the
executions of the function.
• Reset Wi-Fi Password for Projection
By selecting this function a popup will
appear with the request to confirm
the intention to change the Wi-Fi
password. Select "Yes" and then "OK"
to reset the password, or "Cancel" and
"X" to close the popup without reset
the Wi-Fi password.
• Reset Performance Values
By selecting this function a popup will
appear with the request to confirm the
intention to reset performance values.
Select "Yes" and then "OK" to reset the
values, or "Cancel" and "X" to close the
popup without reset the performance
values.
• Factory Reset
Selecting this function a popup will
appear with the request to confirm
the intention to reset the MIA to the
factory defaults. The "Yes" choice
will cause the MIA to restart and the
backup camera, the radio, SOS Call and
several driving assistance functions will
not available. This could take several
minutes. Select "Cancel" or "X" to close
the popup without resetting the factory
defaults.
Mobile Phone Pairing
NOTE:
This operation is only possible with the
vehicle stationary because the “Add
Device” function is disabled while in
motion.
1. Ensure that Bluetooth
®
is enabled on
your phone.
2. Touch the “Phone” soft-key on the
main category bar of the MIA. If there are
no paired devices, a pop up will invite
you to choose.
3. If you choose “Yes”, the system will
search for available devices on your
Bluetooth
®
-enabled mobile phone (go to
step 7).
4. If you have selected “No” instead and
you want to choose between one of
the already paired phones or pair a new
one, the system will load the following
screen.
5. Touch the “Device Manager” soft-key
to see the paired devices.
6. To pair a new device, touch the “Add
Device” soft-key to start the pairing
process.
NOTE:
For the next steps, you will need to use
the mobile phone controls.
7. The “Bluetooth Pairing” screen with
a randomly generated pin will be
displayed. Touch “Search" for Bluetooth
Devices” soft-key. On your phone the
available devices are usually in the
“Settings” or “Bluetooth Options”
menus. If not so, look up in your phone's
manual. A randomly generated pin will
be displayed.
8. If your phone being paired uses
SSP Pairing the screen will change in
the following screen with a randomly
generated 6 digit pin after you have
selected “Uconnect” on your device.
9. At this point, to start the pairing
process you need to confirm the pin
matches the one displayed on your
phone by touching the “Yes” soft-key.
10. If the pairing process was successful,
the following screen will be displayed.