5
196
Driving and Driver Assistance Systems
NOTE:
To avoid unintentional shutdowns, the
system will disable the one time press
of the soft-key on the Maserati Connect
App for two seconds after receiving a
valid “Remote Start” request.
To exit Remote Start Mode and
Drive the Vehicle
Before the end of the 15-minute cycle,
press and release the button on the
key fob to unlock the doors and disarm
the vehicle security alarm. Then, prior
to the end of the 15-minute cycle, press
and release the START/STOP button.
NOTE:
The message “Remote Start ON
Push Start Button” will display in the
instrument cluster until you push the
START/STOP button.
Driver's Seat Comfort with
Remote Start
The driver's heated and ventilated
seat and the heated steering wheel
(if foreseen) can be programmed to
come on during a remote start. Refer to
“Auto-on Comfort” function of the "Seats
& Comfort" submenu in the "Settings"
page (see chapter “Functions of Settings
Menu on MIA” of section “Dashboard
Instruments and Controls” for further
information).
Radio Frequency RKE
Transmitter - Regulatory
Information
The “Regulatory Information” for all
the radio frequency and radar devices
can be consulted by accessing the
section “Services” on the website
www.maserati.com.
Automatic Start&Stop
System
The Maserati Start&Stop system allows
the engine to automatically switch off
when the vehicle stops and to restart
when the driver intends to drive. This
function helps reduce fuel consumption.
During the “Stop (AutoStop)” phase
the ignition is still on and all security
functions are available. In order for the
Start&Stop to activate, the vehicle
must be stationary and the brake pedal
adequately pressed.
NOTE:
If the brake pedal is not sufficiently
pressed the Start&Stop may not
function even if the vehicle is stopped.
When the Start&Stop switches off the
engine, the related light illuminates
on the instrument cluster.
As soon as the brake pedal is released,
the engine turns on.
While the vehicle is stopped, the
transmission can be placed in P
(Park) pressing the “P” button on the
dashboard. Releasing the brake pedal
will cause a recrank of the engine.
To Next Page
Loading...
