5
219
Driving and Driver Assistance Systems
Park Assist
The Park Assist system provides visual
and audible indications of the distance
between the rear and/or front bumper
and a detected obstacle when backing
up or moving forward, e.g. during a
parking maneuver.
Besides the use of the sensors available
on the bumpers and of the rear parking
camera, the vehicle may be equipped
with surround view cameras ( ) to
assist the driver during maneuvers on
dead-ends/roads and on intersections.
For more details on this option, see
chapter "Surround View Camera
System" in this section.
Refer to “Park Assist System Usage
Precautions” in this chapter for
limitations of this system and
recommendations. Park Assist settings
will retain the last system state (enabled
or disabled) from the last ignition cycle
when the ignition device is changed to
the ON position.
Park Assist system can be active only
when the transmission is in R (Reverse),
D (Drive) or in movement when in N
(Neutral) mode.
If Park Assist is enabled at one of these
gear shift positions, the system will
remain active under approximately 7
MPH (11 km/h).
NOTE:
When in D (Drive) mode, no information
about rear obstacles will be shown.
Park Assist Sensors
The six Park Assist sensors, located in
the rear bumper, monitor the area behind
the vehicle that is within the sensor's
field of view. The sensors can detect
obstacles from the rear bumper in the
horizontal direction, depending on the
location, type and orientation of the
obstacle.
MODENA Version
TROFEO Version
The six Park Assist sensors, located in
the front bumper, monitor the area in
front of the vehicle that is within the
sensor's field of view.
The sensors can detect obstacles from
the front bumper in the horizontal
direction, depending on the location,
type and orientation of the obstacle.
MODENA Version
To Next Page
Loading...
