5
231
Driving and Driver Assistance Systems
NOTE:
The system must be disengaged when
not in use.
Speed Range of Use
Speed MPH (km/h)
Minimum 0
Engaged/activated 18 (30)
Maximum 155 (250)
Setting
Turn on the SL function when the vehicle
has reached the desired speed, push
the button (SET-) and the system sets
and visualizes beside the green light
the current speed limit (in the example
shown 30 MPH).
Pushing the button (SET +) or (SET -)
once, or long pressing it will enable to
increase or decrease the set speed by
one unit (1 MPH or 1 km/h).
If the car is equipped with ADAS
Systems, the short press of the button
will increase or decrease the set speed
of 1 MPH or 1 km/h; a long pressure of
the same will increase or decrease the
set speed of 5 MPH or 10 km/h.
Release the button when the desired
speed is reached, and the new set speed
will be visualized beside the green light.
The set speed memory can only be
erased by pressing the ON/OFF
button or by turning the ignition off.
Temporary Deactivation
A press of the button (CANC), with SL
function on, erases temporarily the
set speed memory, that will remain
displayed beside the white light.
Pressing the brake pedal the SL function
remains engaged, while the CC function,
if it was active will be temporarily
deactivated.
To resume the set speed, read the next
paragraph.
Resume Speed
To resume a previously set speed, push
the button (RES) and release it.
If you resume the set speed, but driving
at a higher speed, the message shown in
the picture below appears on the display
and a buzzer alerts the driver.
The system cuts the engine torque and
the green light with beside the set
speed will turn on.
Drive Override
If the driver presses the accelerator
pedal to overtake another vehicle and
exceeds the set speed limit, the set
speed and the green light will blink
until the speed returns below the set
speed.
It is possible to do so at any driving
speed, considering that it is possible to
To Next Page
Loading...
