2
85
Understanding the Vehicle
2 Press and hold the desired
HomeLink
®
button until the indicator
light begins to flash after 20
seconds. Do not release the button.
3 Without releasing the button,
proceed with “Canadian/Gate
Operator Programming” step 2 and
follow all remaining steps.
Using HomeLink
®
To operate, press and release the
programmed HomeLink
®
button.
Activation will now occur for the
programmed device (i.e., garage door
opener, gate operator, security system,
entry door lock, home/office lighting,
etc.). The hand-held transmitter of the
device may also be used at any time.
Security
It is advisable to erase all channels
before you sell or turn in your vehicle. To
erase the channels press and hold the
two outside HomeLink
®
buttons (I and
III) until the warning light starts flashing
(after approximately 20 seconds).
The HomeLink
®
Universal Transceiver is
disabled when the vehicle security alarm
is active (see chapter “Anti-theft Alarm
Systems” in this section).
Troubleshooting Tips
If you are having trouble while
programming HomeLink
®
, here are some
of the most common solutions:
• Replace the battery in the original
hand-held transmitter.
• Press the LEARN button on the garage
door opener to complete the training
for a rolling code.
• Did you unplug the device for
programming and forgot to plug it back
in?
If you have any problems, or require
assistance, please call toll-free
1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or
assistance.
NOTE:
You can consult the list of compatible
devices with the HomeLink
®
, and their
level of compatibility, on the website
www.HomeLink.com.
Radio Frequency RKE
Transmitter - Regulatory
Information
The “Regulatory Information” for all
the radio frequency and radar devices
can be consulted by accessing the
section “Services” on the website
www.maserati.com.
To Next Page
Loading...
