MASERATI GRANTURISMO MC TROFEO/GT4 SERVICE MANUAL
37
Ver 1.0 2/16
Important note: adjust the pushrods of the master cylinders so that the balance bar is
perpendicular to the pushrods under maximum load. The system is then square. It is not
important that the system is square when released, but it has to be under load.
8.4.4.
Balance knob
The balance knob is located on the central console, as shown in the picture.
The brake balance can be modified by turning the knob as follows:
- CLOCKWISE TO CHANGE THE BRAKE BALANCE TO THE FRONT AXLE
- ANTI-CLOCKWISE TO CHANGE THE BRAKE BALANCE TO THE REAR AXLE
NOTE
The modification of the original setting (50 ANT / 40 POST) MUST BE DONE EXCLUSIVELY
with the brake pedal fully released (also if the car is moving).
To Next Page
Loading...
