11.2.
Suspension Assembly
When checking and / or replacing suspension parts or when cleaning and lubricating the
suspension joints, the disassembly of the suspension is needed.
Following the procedure below to reassemble the parts correctly.
11.2.1.
Front Suspension
The bushings of the suspension arms should be assembled as in the photos below
Remember to apply grease (driveshaft or ball bearing grease) between the bushing and the
inner steel sleeve.
Fit the complete suspension assembly (hub carrier and arms) to the subframe, holding the
arms in place by inserting the bolts. Pull the upper arm towards the front and locate the
contact point (in the photos, the front joint of the upper arm). Apply spacers as needed to fill
the clearance on the other side of the joint, as shown below.
To Next Page
Loading...
