6
215
Driver Assistance Systems
Instrument cluster overview in section
"Dashboard Instruments and Controls".
Displayed information depends on
system status: ready, set, temporarily
cancelled or override.
Activation
Push the ON/OFF button to engage
the system. The white light in upper
right sector of the display will illuminate
and the last set speed is shown.
To disengage the system, push the same
button a second time. The light will
turn off and a new message pops up for
5 seconds, then the display returns to
the previous setting.
When the SL function is activated, the
system automatically disengage the CC
function if it was active. See chapter
"Cruise Control - CC" in this section for
further information.
NOTE:
The system must be disengaged when
not in use.
Speed Range of Use
Speed km/h (mph)
Minimum 0
Engaged/activated 30 (18)
Maximum 250 (155)
Setting
Turn on the SL function when the vehicle
has reached the desidered speed, push
the button (SET-) and the system sets
and visualizes beside the green light
the current speed limit (in the example
shown 30 km/h).
Pushing the button (SET +) or (SET -)
once, or long pressing it will enable to
increase or decrease the set speed by
one unit (1 km/h or 1 mph).
If the car is equipped with ADAS
Systems, the short press of the button
will increase or decrease the set speed
of 1 km/h or 1 mph; a long pressure of
the same will increase or decrease the
set speed of 10 km/h.
Release the button when the desired
speed is reached, and the new set speed
will be visualized beside the green light.
The set speed memory can only be
erased by pressing the ON/OFF
button or by turning the ignition off.
Temporary Deactivation
A press of the button (CANC), with SL
function on, erases temporarily the
set speed memory, that will remain
displayed beside the white light.
Pressing the brake pedal the SL function
remains engaged, while the CC function,
if it was active will be temporarily
deactivated.
To Next Page
Loading...
