7
254
In an Emergency
mode and set the ignition device to
STOP.
• If using another vehicle to jumpstart
the battery, park the vehicle within
the jumper cables reach and set the
parking brake and make sure the
ignition is off.
• Connect one terminal clamp of the
positive jumper cable to the positive (
+) remote post of the vehicle with the
discharged battery after lifting the
protection cap of the cable indicated.
• Connect the opposite terminal clamp
of the positive (+) jumper cable to the
positive (+) post of the booster battery.
• Connect one terminal clamp of the
negative jumper cable to the negative (
–) post of the booster battery.
• Connect the opposite terminal clamp
of the negative (–) jumper cable to
the remote negative (–) post of the
vehicle with the discharged battery as
rendered.
3.0 V6
2.0 L4 MHEV
• Start the engine in the vehicle that has
the booster battery, let the engine idle a
few minutes, and then start the engine
in the vehicle with the discharged
battery. If using a portable battery
booster, wait a few seconds after
connecting the cables, before starting
the booster vehicle.
Once the engine is started, remove the
jumper cables in the reverse sequence.
• Disconnect the terminal clamp of the
negative (–) jumper cable from the
remote negative (–) post of the vehicle
with the discharged battery.
• Disconnect the opposite terminal clamp
of the negative jumper cable from the
negative (–) post of the booster battery.
• Disconnect the terminal clamp of the
positive (+) jumper cable from the
positive (+) post of the booster battery.
• Disconnect the opposite terminal clamp
of the positive jumper cable from
the remote positive (+) post of the
discharged vehicle.
NOTE:
If frequent jump-starting is required to
start your vehicle you should have the
battery and charging system inspected
at an Authorized Maserati Dealer.
To Next Page
Loading...
