Venting Sunroof
Press and release the rear button; the
sunroof front panel will open to the
vent position. Where this function is
available, this type of opening can be
activated regardless of the sunroof
position. During this opening
operation, any movement of the
button will stop the sunroof.
By pressing the rear button when the
sunroof is completely closed, the latter
will open to the venting position.
Sunshade
Press backwards and release the left
switch: the sunshade will move to the
vehicle rear side until completely open.
From this position, press onwards and
release the left switch to move the
sunshade to the vehicle front side until
completely closed.
During the opening and closing
operations, work on backward and
onward the left switch to interrupt the
sunshade movement in any position.
Pinch Protect Feature
This feature will detect an obstruction
in the roof opening during the
automatic closure or a constant
obstruction of the sunroof front panel.
If an obstruction is detected by the
safety system during the closing
movement, the sunroof front panel
will automatically retract. If this occurs,
remove the obstruction then press
onwards and release the right switch
to reactivate the sunroof automatic
closure.
NOTE:
• If three consecutive attempts to close
the sunroof result in pinch protect
reversals, the fourth attempt will be
manual, with pinch protect feature
disabled.
• Pinch protection is disabled while
pressing the switch/es.
Initialization Procedure
In case of a fault in the automatic
opening/closing movements or in case
of battery removal, it is necessary to
initialize the automatic operation of
the sunroof.
Proceed as follows:
• bring the sunroof in the completely
closed position;
• push the ignition switch to OFF
position and keep this condition for
10 seconds;
• push the ignition switch to RUN
position;
• press the right switch onwards and
keep it pressed for at least 10
seconds after which you should hear
the sunroof electric motor mechanic
stop;
• within 5 seconds, press the right
switch onwards again and keep it
pressed: the sunroof performs an
automatic complete opening and
closing cycle. Should this not happen,
repeat the procedure from the
beginning;
• press the right switch onwards and
keep it pressed until the sunroof is
completely closed: the initialization
procedure is then completed.
Closing and Opening the Power
Sunroof with RKE Transmitter
and Ignition Off
When the ignition switch is in OFF
position, if the sunroof is open, it can
be closed together with the windows
by pressing the
button on the RKE
transmitter (refer to “Power
Windows” in section “Before
Starting”).
• Press and release the
button.
• Press a second time the
button
and keep it pressed until the sunroof
is completely closed.
Understanding the Vehicle
3
142
To Next Page
Loading...
