EasyManua.ls Logo

Maserati MC20 2022 - Launch Control Mode

Maserati MC20 2022
288 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
179
Starting and Driving
Pushing the button, the LED will
switch from red to white, chancing in
"MID" trim. A amber telltale will be
displayed on the instrument cluster.
NOTE:
WET, GT and SPORT are not selectable
starting from ESC OFF Mode.
Launch Control Mode
"Launch Control" mode is a
performance start procedure. By
activating this procedure you get
the best possible acceleration from
standstill of the car.
To make a performance start in
"Launch Control" mode, the following
conditions must be met:
Water and transmission temperature
not too cold or too warm.
No sever vehicle malfunctions.
The powertrain mileage must be
higher than 500 mi (800 km).
NOTE:
The powertrain limitation mileage
prevents the Launch Control use even
after 500 mi (800 km) as long as the
vehicle is switched off. At next key-on,
the powertrain limitation will be no
longer present.
Drive mode on "CORSA" mode.
Brake pedal pressed.
Gearbox transmission in "D" or"M"
mode.
The vehicle must be stationary on
a level road surface, with straight
wheels.
Parking brake must not be engaged.
NOTE:
If water and transmission
temperature are cooler than proper
range, a pop-up will be displayed on
the instrument cluster to inform that
transmission is not ready.
If the brake system or the ECM are
faulty, a generic pop-up will be
displayed on the instrument cluster.
If the engine is not ready, the relative
pop-up will be displayed on the
instrument cluster.
If vehicle is not on a level ground,
a pop-up message will inform the
driver that the Launch Control is not
available.
If steering wheel is not straightened,
a pop-up message will inform the
driver that the Launch Control is not
available.
If vehicle vehicle speed is above
threshold, a pop-up message will
inform the driver that the Launch
Control is not available.
If there is a relevant error on the
gearbox side, a pop-up message will
inform the driver that the Launch
Control is not available.
Pressing the brake pedal will activate
the Launch Control Mode. If the
brake pedal is not pressed, a pop-up
(Continued)

Table of Contents

Related product manuals