4
116
Instruments and Controls
acceleration is higher and cross the
second level the circle flashes and is red
colored (Stage 3).
At the left and right side of the circle is
shown the value peak related to the
lateral acceleration (see example in
picture).
The peak value is shown only when
the lateral acceleration overcomes
the minimum threshold value. The
visualization of a peak value can be
replaced by a new peak value if the
lateral acceleration overcomes the
minimum threshold on the same side.
If a lateral acceleration overcomes the
minimum threshold on the other side,
two peak values will be displayed at the
same time (on the left and on the right of
the circle).
The peak value is updated in real time
to the highest value received from CAN
network.
G-Meter - CORSA Mode
When in CORSA mode, the dot, the
contrail and the circle instead of red they
are yellow.
Acceleration is represented in the same
way as for GT and SPORT mode (see
example in picture).
The representation of the acceleration
peaks is specific to this drive mode.
The top peak is shown only when the
longitudinal acceleration overcomes the
minimum acceleration threshold value,
while when the longitudinal acceleration
overcomes the minimum braking
threshold value is displayed the bottom
peak.
Temperatures Display
“Temperatures” is a content that can be
displayed on the right side contents area
(see “Controls to Set and Configure the
Instrument Cluster” in this section).
This area displays the temperature of the
following parts:
• Engine
• Transmission
• Carbon Brakes ( ).
Temperatures colors changes
dynamically with current temperature of
the part.
• Blue: it means the part is cold.
• White: it means the part is warm.
• Red: it means the part is hot.
When the image is all in grey, it means
that there was a fail. In this case, contact
an Authorized Maserati Dealer.
To Next Page
Loading...
