Maserati MC20 2023 - Page 172

5
170
Starting and Driving
Transmission status is visible on the
central part of the instrument cluster
display, except in the full map mode,
where it is located in the bottom right.
To Engage a Mode (briefly)
To select one of the operating modes,
press one of the buttons previously
indicated and press the brake pedal at
the same time.
To engage "P" mode, driver must switch
OFF the vehicle.
In order to engage "R" or "D/M" mode,
driver have to press the corresponding
button.
• To engage the N (Neutral) mode from P
(Park), R (Reverse) or D (Drive) mode,
press the brake pedal and pull both
shift paddles behind the steering
wheel.
• To engage the R (Reverse) mode from
P (Park), N (Neutral) or D (Drive) mode,
press the brake pedal and push the R
(Reverse) button on the central tunnel.
• To engage the D (Drive) mode from P
(Park), N (Neutral) or R (Reverse) mode,
press the brake pedal, push the D/M
(Drive/Manual) button on the central
tunnel and pull the "+" shift paddle.
• To engage the M (Manual) mode from P
(Park), N (Neutral) or R (Reverse) mode,
press the brake pedal, push the D/M
(Drive/Manual) button on the central
tunnel twice and pull the "+" shift
paddle.
• It is possible to use the M (Manual)
mode moving from D (Drive) mode
by pushing the D/M button, without
pressing the brake pedal.
• To engage the P (Park) mode from D
(Drive), N (Neutral) or R (Reverse) mode,
press the brake pedal and switch OFF
the vehicle.
CAUTION!
•
DO NOT accelerate while shifting from
P (Park) or N (Neutral) to another mode.
•
After selecting a transmission
mode, wait a few seconds before
accelerating. This precaution is
particularly important with a cold
engine.
Transmission Status on the Instrument
Cluster Display
The gear position field (PRNDM) is
shown in a bar that is always visible at
the central part of the instrument cluster
display, except in the full map mode,
where it is located in the bottom right.
The current gear is highlighted in the
field and displayed standalone and
enhanced in an adjacent area that
changes according to the drive mode or
to the presence of the map:
• Below the gear position field bar (GT
and WET mode);
• Above the gear position field bar
(SPORT and CORSA mode);
• On the left of the gear position field bar
(full map mode).