5
181
Starting and Driving
cluster to inform that transmission is
not ready.
• If the brake system or the ECM are
faulty, a generic pop-up will be
displayed on the instrument cluster.
• If the engine is not ready, the relative
pop-up will be displayed on the
instrument cluster.
• If vehicle is not on a level ground, a
pop-up message will inform the driver
that the Launch Control is not available.
• If steering wheel is not straightened, a
pop-up message will inform the driver
that the Launch Control is not available.
• If vehicle vehicle speed is above
threshold, a pop-up message will
inform the driver that the Launch
Control is not available.
• If there is a relevant error on the
gearbox side, a pop-up message will
inform the driver that the Launch
Control is not available.
• Pressing the brake pedal will activate
the Launch Control Mode. If the brake
pedal is not pressed, a pop-up will be
displayed on the instrument cluster.
Launch Control Sequence
NOTE:
• All the above mentioned conditions
must be verified in order to activate
"Launch Control" performance start
procedure.
• During “Launch Control” FCW is
temporarily disabled.
• Each step displayed on the instrument
cluster has a time out approximately of
5 seconds.
• "Launch Control" maneuver requires
to use both foot, left foot to brake and
right foot to accelerate at the same
time.
• With engine on, parking brake
disengaged, brake pedal pressed, press
Launch Control button on the steering
wheel.
The instrument cluster shows the
"LAUNCH ON" message.
• To confirm the "Launch Control"
sequence, press the brake pedal. With
brake pedal pressed with left foot, fully
press the accelerator pedal (with right
foot).
• Release brake pedal. The launch of
the vehicle starts with engine torque
calibrated to maximize performance.
• During the acceleration phase the
“Launch Control” symbol appears at
To Next Page
Loading...
