6
234
In an Emergency
CAUTION!
When the disabled vehicle is secured on
the flatbed of a breakdown truck, do not
use the components of the front and rear
suspension as fastening points. Secure
in an incorrect manner may damage the
vehicle.
The assistance truck operators must be
informed about the minimum ground
clearance of the vehicle in order to avoid
contact between the ends of the bumper
with the breakdown truck equipment.
The front and rear attachment corners of
the vehicle shown on the picture, to be
taken into consideration when loading
the vehicle on the assistance truck.
A: 8.9°
B: 8.9°
CAUTION!
It is forbidden to tow any other type of
vehicle witch this car.
Use the Tow Hook Included in
the Tool Kit
CAUTION!
The tow hook should only be used for
towing the disabled vehicle on flat roads.
Do not use the tow hook to remove the
car that is stuck on off-road stretches.
The tow hook is contained in the tool kit
(see "Tool Kit" in this section) and must
be screwed in its seat accessible behind
the front grille, right-hand side, after
removing the protective cap.
• Carefully clean the threaded seat
before screwing the hook.
• Screw the tow hook into its seat for at
least 11 turns.
NOTE:
Maximum work angle of towing cable or
bar: 15
°
.
To Next Page
Loading...
