Maserati MC20 2023 - Cup Holder

2
53
Understanding the Vehicle
CAUTION!
•
The electric power outlet is directly
connected to the 12 V battery.
Plugging accessories with engine off
can discharge the battery.
•
Do not plug in accessories that exceed
the maximum power of 160 Watts (13
Amps) at 12 Volts.
•
Power outlet is designed for accessory
plugs only. Do not insert any other
object in the power outlet as this will
damage the outlet and blow the fuse.
Damages caused by improper use of
the power outlet are not covered by
the New Vehicle Limited Warranty.
WARNING!
To avoid serious injury or death:
•
Only devices designed for use in this
type of outlet should be inserted into
any 12 Volt outlet.
•
Replacing the fuses that protect power
outlet with others of higher amperage,
there is the risk of fire.
•
Do not touch with wet hands.
•
Close the lid when the plug is not used
and while driving the vehicle.
•
If this outlet is mishandled, it may
cause an electric shock and failure.
Cup Holder
The vehicle is equipped with a cup
holder positioned on the end of the
central tunnel.
CAUTION!
•
Use light and shatterproof containers.
•
Do not forcefully push unsuitable
containers into the cup holders to
prevent damage to the containers.
•
Do not store hot drinks.
Multimedia Ports
Multimedia ports are located inside the
compartment accessible by lifting the
armrest on the central tunnel.
The USB ports (Type-A and Type-C)
inside this compartment can be used
for data exchange and charge of the
connected source (refer to the "Maserati
Intelligent Assistant™ (MIA)" guide for
further details).
Through these USB ports is possible
to recharge the connected device for
about an hour from when the ignition
device is turned STOP ("Active Charging"
function). When this function is enabled,
the USB port will be backlight.
NOTE:
Just one USB at time can be used as
media source: so if both have device
attached just one will work as media
source, the other one is not selectable
from the source media and will work just
as charge port.
Following conditions can create USB
inputs damage or malfunction:
• Usage of non-original lighting cables.