6
198
If a tire gets a puncture
Refitting the standard wheel
– Following the procedure described
before, lift the car and remove the
spare wheel.
– Fit the standard wheel.
– Snug the studs using the special
wrench.
– Lower the vehicle and remove the
jack.
– Fully tighten the studs following the
sequence indicated before.
Observe the tightening
torque for the wheel studs
(98 ± 10 Nm / 72 ± 7 ft. lbs).
On completion of the operation:
– Thoroughly deflate the spare wheel,
exerting pressure on the valve
through the protruding piece of the
valve cap.
– Position the jack and the wrench
with the bushing in their box and put
it back into the spare wheel.
– Place the spare wheel into its bag
and secure it inside the luggage
compartment.
The used wheel may soil the
mats, therefore protect them
if possible.
After refitting the standard
wheel, check the tire pressure.
The jack can be used only to
replace the wheels. It should
never be used for repairs
under the vehicle.
M139_UM_usa1.book Page 198 Monday, September 1, 2008 2:39 PM
To Next Page
Loading...
