3
Internal Equipment
91
Reprogramming a single key
If you want to program activation of a
new system on an already used
HomeLink key, proceed as follows:
– press and hold down the HomeLink
key selected;
– after about 20 seconds, the LED K
starts flashing; keep the key pressed
down;
– hold the original remote control of
the device to be controlled close to
the HomeLink control panel (12 in);
– press and hold down the original
remote control key;
– successful programming is signaled
by the LED K flashing faster;
– release both keys.
The system previously programmed on
HomeLink has thus been replaced with
the new programming and is ready to
be used.
This operation has no impact on the
other HomeLink keys.
Deleting the programmed keys
Unlike programming which is done for
each individual key, deletion is done
for all three keys simultaneously.
To delete, proceed as follows:
– press and hold down the keys H and
J;
– after about 20 seconds, the LED K
starts flashing;
– release the keys.
WARNING: It is advisable to carry out
the HomeLink deletion procedure
when selling the vehicle.
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This
device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following
two conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference that may
cause undesired operation of the
device.
M139_UM_usa1.book Page 91 Monday, September 1, 2008 2:39 PM
To Next Page
Loading...
