1 - 13
INTRODUCTION
Tractor identification and technical specifications
2-8 4WD (DNX) front axle specifications
Type of axle In spheroidal cast iron, oscillating with central pivot
Type of reductions Standard axle with central pinion and ring gear (
MF 2210-2225
):39/8
Standard axle withcentral pinion and ring gear (
MF 2235
):53/13
Sherpa axle with central pinion and ring gear (
MF 2210-2225
):41/9
Sherpa axle with central pinion and ring gear (
MF 2210-2225
):51/13
Standard axle with dropped final drive (
MF 2210-2225
):47/11
Sperpa axle dropped final drive 4.6
Clutch control Mechanical with hand lever or electrohydraulic
Ratio between front and rear axle 1.430 with 4 WD
2.500 with Fast Run
Type of hydraulic clutch Hydraulic clutch for 4 WD with oil-cooled disks
electrohydraulic control with 1:1 input/output ratio
Hydraulic clutch with oil-cooled disks for Fast Run
with automatic engagement when the steering angle
exceeds 35°.
Input/output ratio 1:1.78
Max. steering angle 55°
Max. angle swing 8°
Turning radius 3054 mm.
To Next Page
Loading...
