MASSEY FERGUSON MF4200 Series - Page 7

4.2.3 Front axle (4x4) ..................................................94
4.2.3.1 Instructions for changing the track ..............................94
4.2.3.2 Steering angle .............................................95
4.2.4 Rear axle track ...................................................95
4.2.4.1 Rice wheels ..............................................96
4.2.4.2 Wheel with die-cast disc .....................................96
4.2.4.3 Rear wheels with PAVT system ................................96
4.3 Recommended tyres for your tractor .................................99
4.3.1 Compatibility of front x rear tyres .....................................99
4.3.1.1 Recommended combinations for rear x front wheels .................99
4.3.2 Operation with Dual Wheels ........................................101
4.4 Power Take-Off ....................................................102
4.4.1 Changing the clutch stage ..........................................102
4.4.1.1 After using the PTO ........................................103
4.4.2 Independent Power Take-Off Operation ................................103
4.4.3 General Guidelines of use for the (I)PTO ............................... 103
4.4.4 Changing the output shaft ..........................................105
4.4.5 Changing the dashboard programming ................................ 106
4.5 Draw Bar ..........................................................107
4.5.1 Changing the height of the draw bars ................................. 107
4.5.2 Changing the length of the draw bars ................................. 108
4.5.3 When operating with the draw bar ................................... 109
4.6 Roll-Over Protective Structure (ROPS) ...............................111
4.6.1 Procedure for folding the ROPS (If installed) ............................ 112
4.7 Prior to start-up ................................................... 113
4.8 Before starting the job ............................................. 114
4.8.1 ATS electrical system .............................................114
4.9 Stopping the tractor ............................................... 115
4.9.1 Emergency stop .................................................115
4.10 Start-up and movement of the tractor ............................. 116
4.10.1 Influence of the tractor protection system ............................. 116
4.10.2 Influence of the protection system on tractor servicing ....................117
4.10.3 Alternative start-up features ....................................... 117
4.11 Break-in instructions - New engine ................................ 119
4.12 Operations below 0°C .............................................120
4.13 Engagement and use of front-wheel drive ..........................121
4.14 Gear Selection ................................................... 122
4.14.1 Engine Speed and the PTO ........................................122
4.14.2 Using the table of speeds .........................................122
4.15 Hydraulic lift system ..............................................124
4.15.1 Identification of components .......................................124
4.15.2 Adjustments before operation ......................................124
4.15.2.1 Adjusting the side stabilizers ................................ 127
4.15.3 Lift system categories ........................................... 128
4.15.4 External auxiliary hydraulic cylinders ................................. 129
4.15.5 Procedures for coupling and uncoupling implements ..................... 129
4.15.5.1 Uncoupling Implement .....................................130
4.15.6 Hydraulic lift system .............................................131
4.15.6.1 Traction Control (depth) outer lever - yellow selector ............... 132
4.15.6.2 Position control - inner lever - red selector .......................133
4.15.6.3 Position control .......................................... 133
4.16 Use of the remote control .........................................134
4.16.1 Presentation ...................................................134
4.16.1.1 Combined flow .......................................... 134
4.16.1.2 Valve types ............................................. 135
Table of contents
MF4200
6269696M4
Find manuals at https://best-manuals.com