15. MAINTENANCE
Steering Inspection
The steering assembly of the machine should be checked
periodically for loose nuts and bolts. If loose nuts and bolts are
found, have your dealer tighten them before riding your vehicle.
Camber and Caster
The camber and caster are non-adjustable.
WARNING
Do not attempt to adjust the tie rod for toe alignment. Severe
injury or death can result from improper adjustment.
Contact your dealer. He/she has the training and tools to make
these adjustment.
Toe Alignment Check
The recommended toe alignment
is 1/8”to 1/4”(3to6mm) toe out.
1. Set the handlebars in a
Straight ahead position and
Hold them in this position.
2. Measure A and B,A minus
B should be 1/16” to 1/8”
(1.5 to 3mm).
3. If this measurement needs
to be adjusted, contact your
dealer for service.
To Next Page
Loading...
