15. MAINTENANCE
Storage Tips
CAUTION
Do not start the engine during the storage period. This will disturb
the protective film created by fogging.
Cleaning——Clean the ATV thoroughly.
Oil Add and Filter Change——Warm the engine and change oil
and filter.
Air Filter/Air Box——Inspect and clean or replace the air filter
element. Clean the air box.
Inspect All Fluid Levels——Inspect the following fluid levels
and change if necessary: transmission; brake fluid (change every
two years or as required if fluid looks dark or contaminated).
Fog the Engine——Spray a light oil into the cylinder through the
spark plug hole.
Check and Lubricate Cables/Grease——Inspect all cables and
lubricate.
Battery Maintenance——Remove the battery and Apply
dielectric Grease to the terminal bolts and terminals. Charge the
battery.
Storage Area/Covers——Set tire pressure and safely support
the ATV with the tires 1-2”(25-50mm) off the ground. Be sure the
storage area is well ventilated. Cover the machine with a ATV
cover.
NOTE: Do not use plastic or coated materials. They do not allow
enough ventilation to prevent condensation, and may promote
corrosion and oxidation.
To Next Page
Loading...
