OPERATION OPERATION
Rear wheel installation/removal
Installation: Insert the rear wheel into the rear wheel bracket.
Push until you hear a “click”: this indicates that the wheel is
correctly installed.
Press the red button and then pull the wheel out to remove.
Front bar installation/removal
Installation: Insert the protective bar into the frame in the
direction of the arrow. Push the bar until you hear a “click”
indicating that the bar has been correctly assembled.
Unfolding: Press one of the two central buttons on each side
of the frame to release the rear bar.
WARNING: Never hold the front bar to lift up the pushchair
when there is a baby in the seat!
Removal: Press the two buttons on each side
of the frame, then raise the bar in the direction of the arrow.
Canopy adjustment:
To fold the canopy: Pull backwards on the front edge.
To open the canopy: Push forward on the front edge of the
canopy while holding the rear of the canopy in place.
Leg rest adjustment:
As shown in the picture: Pull the adjusting device below the leg
rest to adjust the angle of the leg rest up or down.
30
To Next Page
Loading...
