12
Burner Flame Check
Light burner then rotate regulator knob from HIGH to LOW.
You should see a smaller flame in LOW position than on HIGH.
Always check flame prior to each use.
The air damper mounted on the back of your burner helps to
control the amount of primary air that mixes with the LP gas.
A blue flame with little or no yellow flame provides the best
heat. Adjust the air damper by turning it clockwise or
counter-clockwise until the desired flame is achieved.
Turning LP Cooker O
Turn all knobs to OFF position. Turn LP tank OFF by
turning OPD hand wheel clockwise to a full stop.
Hose Check
• Before each use, check to see if there is evidence of abrasion,
wear, cuts or leaks. If any problems are found, the hose must be replaced prior to the appliance
being put into operation.
The replacement hose assembly shall be that specified by the manufacturer.
• Clean and inspect the pressure regulator and hose assembly prior to use.
Cleaning the Burner
Cleaning and Maintenance
CAUTION:
Check and clean burner/venture tubes to eliminate insect nests. A clogged tube can lead to fire
beneath the appliances.
Spiders’ nests or wasps’ mud inside the burner may cause fire at the air damper. If a fire occurs,
immediately turn o gas supply at LP tank valve.
Note:
Spiders and small insects can spin webs and build nests inside the burner. This especially occurs
in late summer and fall before frost when spiders are most active. These nests can obstruct gas
flow and cause a fire in and around the burner and orifice. Such a fire can cause operator injury
and serious damage to the appliance. To help prevent a blockage and ensure full heat output,
clean and inspect burner tube often (once or twice a month).
NOTE: Water or air pressure will not normally clear a spider web.
Holes in Burner
Good
Bad
Yellow
Blue
Blue
Yellow
Air Damper
Product no. 085-3259-6 (TF2047905-MC-00) |
Contact us: 1-855-803-9313
To Next Page
Loading...
Need help?
General