en
CZ
DE
DK
EE
ES
FI
FR
GB
HR
HU
IT
LT
LV
NL
NO
PL
RO
RU
SE
SI
SK
UA
SE
SI
SK
TR
UA
CONTENTS
1... HOW IT WORKS
2... WHERE TO POSITION
3... BEFORE USE
4... PARTS
5... OPERATION
6... DRAINAGE
7... MAINTENANCE
8... TROUBLE SHOOTING
PLEASE TAKE TIME TO READ THIS MANUAL
CAREFULLY BEFORE USE AND SAVE IT FOR
FUTURE REFERENCE.
► 1. HOW IT WORKS
This product is the dehumidier. It controls relative humi-
dity by passing the air through the unit, forcing the excess
moisture to condense over the cooling elements. Contact
with this cold surface makes the moisture in the air to con-
dense. This condensed water then drains safely into the
water tank. The dried air then passes through the conden-
ser where it is slightly warmed and re-enters the room at a
slightly higher temperature.
► FIG. 1
1. dry warmer air,
2. condenser (warmed coil),
3. evaporator (cold refrigerated coil),
4. moist saturated air,
5. lter,
6. water tank,
7. motor,
8. fan,
9. compressor.
► 2. WHERE TO POSITION
Excess moisture will travel throughout your home, just like
the cooking smells waft to every room in the house. For
this reason, the dehumidier should be positioned in a way
that allows it to draw this moist air towards it from all over
the home.
Alternatively, if you have a serious problem in one area
you can begin with positioning the dehumidier close to
this area and later moving gradually closer to the central
point. When positioning the dehumidier, ensure that it
is placed on a level surface and that there is a minimum
of 10 cm (4”) of space on either side of the unit to allow an
efcient airow.
This dehumidier is equipped with castors for extra mobi-
lity, if you move the unit, it should rst be switched off and
the water tank emptied. The use of an extension lead is
not recommended, so please ensure that the unit is close
enough to a xed mains socket. If it is necessary to use an
extension lead, please ensure the diameter of the wires of
the cable is at least 1 mm
2
.
When the dehumidier is in operation, outside doors and
windows should be closed, when necessary, for more ef-
cient use .
► 3. BEFORE USE
CAUTION!
► Always keep the unit in vertical position.
► Keep the unit in vertical position for one hour before
connecting to the mains supply after transport or when it
has been tilted (e.g. during cleaning).
► Keep all foreign objects away from the air inlet or output
openings.
► The mains supply must conform to the specication
shown on the rating label on the backside of the unit.
► If the supply cord is damaged, it must be replaced by
an authorized service representative or a similar qualied
person in order to avoid hazard.
► Never use the plug to turn the unit on or off. Always use
switch on/off the control panel.
► Before moving the unit, switch it off, then unplug and
empty the water tank.
► Don’t use bug sprays or other ammable substances
nearby the unit.
► Never pour or spray water over the unit.
► THIS APPLIANCE IS NOT INTENDED FOR USE BY
PERSONS (INCLUDING CHILDREN) WITH REDUCED
PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR
LACK OF EXPERIENCE AND KNOWLEDGE , UNLESS
THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUC-
TION CONCERNING USE OF THE APPLIANCE BY A
PERSON RESPONSIBLE FOR THEIR SAFETY. CHILD-
REN SHOULD BE SUPERVISED TO MAKE SURE THEY
DO NOT PLAY WITH THE APPLIANCE.
IMPORTANT!
Do not use this unit at ambient temperatures below
5
o
C, to prevent the evaporating coils from freezing up.
► 4. PARTS
► FIG. 2
1. Metal housing
2. Handle
3. Control panel
4. Hour counter
5. Left panel
6. Caster
7. Filter
8. Water tank
9. Right panel
► FIG. 3
Position of the handle can be adjusted by pressing the but-
ton at the two ends of the handle.
► 5. OPERATION
► Control panel FIG. 4
1. Humidity display
2. Operation indicator
To Next Page
Loading...
Need help?
General
