EasyManua.ls Logo

Master Eclipse - Power Set and Battery Status; Battery Replacement Procedure

Master Eclipse
4 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
THE BATTERY USED ON THIS DEVICE HAS BEEN EXPRESSLY STUDIED FOR OUTSIDE USE. IT IS DANGEROUS AND FORBIDDEN
TO REPLACE THIS BATTERY WITH ONOTHER ONE WITH DIFFERENT TECHNICAL CHARACTERISTICS.
09. Power set.
1
2
PRESS TOGETHER BUTTON
« » AND « » ON THE SENSOR.
THE TWO LEDS FLASH ACCORDING
TO THE POWER SET.
1 2
3 Flashes = MAX CHARGE
+
-
+
-
+
-
+
-
3 = SPENT
REPLACE BATTERY
Flashes
YELLOW LED YELLOW LED YELLOW LED RED LED
The battery duration is estimate at least for 5 years on standard temperature and humidity conditions. However it must be considered that battery
duration can be shorter in particular use conditions. If it is available, it is strongly recommended to keep the “RADIO TEST” function active on the
tuned receiver. If the transmission range performed by the radio sensor, does not reach the tuned receiver anymore, due to the gradual battery
running out, the “RADIO TEST” of the receiver permits the roll up of the awning (around every 20 minutes) until it reaches the protection position
and gives a visible sign of the need to verify the radio sensor and, if it is the case, to replace the battery. While waiting for a specialized technician,
it is possible to temporarily deactivate the “RADIO TEST” following the receiver instruction guide.
10. Battery replacement.
The battery replacement must be carried out by qualified and authorized personnel, complying all the l
The battery must be replaced by one of the same type. Contact your dealer for the spent battery. Considering the sensor conditions of use, the inside temperature of the sensor
can be very high.An unsuitable battery may cause fire hazard or explosion danger.
Remove the bottom unscrewing the 3 fixing screws.
Shift the switch on the « » position.
Removed the spent battery and replace it with a new one respecting polarities.
Shift the switch on the « » position.
Replace the bottom of the sensor with the 3 fixing screws previously removed.
The spent battery must be dispose
If the system does not work, shift the switch on «OFF», waiting some second and
shift again the switch on «ON» verifying that the red led briefly lights, then verify again the sensor working. It is advisable to activate the
TO REPLACE BATTERY:
1.
2. OFF
3.
4. ON
5.
After battery replacement is compulsory verifying the correct working of the system.
aws in force in your locality.
on the proper containers, complying for the law in force in your locality.
«TEST RADIO» on the receivers if it has
been deactivated.
All products and technical characteristics on this document are subjects to variations without any notice.
MASTER declares that the device meets the principal requirements and the other regulations of the directive 1999/5/CE.
The declaration of conformity of the above products is available on the web site ,section «Conformity products»http://www.mastermotion.eu/it-IT/download
Notes.
2 Flashes = MEDIUM CHARGE 1 Flash = LOW CHARGE
.