(A) (B)
ATTACHING THE MOTOR TO YOUR BOAT
Attach the motor to the stern of the boat and tighten both mounting bolts securely while taking care not to over-tighten.
To adjust the angle of the motor after attachment, hold the motor head with one hand and depress the positioning pin at the top
of the mounting bracket with your other hand.
Press and hold the positioning pin until the desired angle has been reached next release the pin and ensure the mechanism locks
securely. (B)
Warning: Before the installation, Make sure the area between column and bracket is clear.
DEPTH ADJUSTMENT
Hold the motor shaft with one hand, loosen the depth adjustment screw and set the motor to the desired depth, then retighten the
adjusting screw securely. (C)
(C) (D)
STEERING
To adjust steering counter-force, simply loosen or tighten the counter force bolt. The ideal setting is one where the counter force
bolt is just tight enough so that the boat will steer in the direction you are aiming without need for continual correction.
To Next Page
Loading...
