Integrity Bath MB-80 Operating Instructions
______________________________________________________________________________________________
MB-80 Operations 2/18/13 800.798.5867
General:
Before operating the Integrity Bath System,
familiarize yourself with the key features of the tub
and carrier components highlighted in the
drawings supplied with these instructions.
Place Individual into Carrier Chair:
Position the Transfer Base and Carrier Chair as
appropriate for transfer from bed, chair, etc. Lock
down both locking casters, of the transfer base, by
stepping down on the Brake Lock Tabs. Rotate
both chair and carrier armrests (up and back out of
the way for the transfer). Make sure the pads are
positioned properly, see page 16 &17, before
making the transfer. If you have a built-in scale on
your Chair Transfer System, push the Zero Button
below the scale readout window to zero out the
weight of the Carrier Chair. With the Chair in the
upright position transfer the individual into the
chair using appropriate ergonomic transfer
techniques per facility protocol.
Secure The Individual:
After the individual is transferred into the chair,
secure them with the security belts and pads
provided. The Upper Body (Chest) Belt is
attached by pushing the hole at one end of the belt
over the Belt Knob and pulling the belt under the
arm; then across the individual, under the other
arm and attach it to the opposite Belt Knob
through the appropriate hole so the belt is snug.
Repeat for the lap and leg belts. Lift leg rest, to
ensure individuals feet are off the floor. As a
variation, you can criss-cross the belts across the
chest. See page 18. Next, rotate the Seat and
Carrier Armrests all the way down over the
individual. Place their hands on the padded
crossbars of the armrests. Unlock the brakes and
transfer the individual into the bath area. Make
sure the tub door is rotated fully open.
See Attached
Components Drawings
Page 10-18
Chest Belt
Lap Belt
To Next Page
Loading...
